The debugging skills of the fully automatic edge banding machine include the following steps:

1. Preparation stage. Clean the machine and the workplace, check whether the dust collection system is normal; check the amount of glue in the glue pot, and add glue if it is insufficient; adjust the position of the auxiliary support rod according to the size of the workpiece; adjust the distance between the upper pressure beam pressure wheel and the lower crawler according to the thickness of the workpiece to ensure that the workpiece is stable and not crushed.
2. Machine settings. Adjust the size of the glue door to make the edge banding material evenly coated; connect the air pipe to keep the air pressure stable (usually 6 standard air pressures); check the power cord connection, test the machine to confirm that the steering and operation are normal; adjust the temperature control meter, heat the rubber wheel to 180℃, and the rubber shaft to 200℃; install the edge banding strip, adjust the position to make it pass smoothly, put the workpiece on the conveyor belt, close to the guide rail, and push it in parallel.
3. Detail adjustment. When using thick edge banding, adjust the position of the pressure wheel; control the temperature of the working room above 12℃ and preheat the edge banding; control the moisture content of solid wood to 8%~10% and keep the substrate clean; pay attention to the temperature of the hot melt adhesive to avoid excessive oxidation or poor fluidity; control the amount of glue applied and check the uniformity of the glue applied.
4. Trimming and pressure adjustment. When using a left-feed model, adjust the handle at the tail of the motor to control the size of the R knife; adjust the pressure and in and out of the upper and lower taper wheels to avoid damage to the workpiece or equipment.
5. Glue pot and side pressure wheel adjustment. Ensure that the amount of glue is appropriate, the glue pot advances and retreats appropriately, and the elasticity is appropriate; clean the return glue hole and the outside of the glue pot to maintain the appearance of the machine and the quality of edge banding.
6. Parameter setting. Set the speed, temperature, and pressure according to the type and thickness of the board.
7. Troubleshooting. If you encounter any problems, check the hot melt adhesive supply, board placement, and machine parameter settings.
In actual operation, these steps should be adjusted appropriately according to the specific machine model and processing materials.